Supplier: Applanix

AP15

The Trimble AP15 GNSS-Inertial System is an embedded GNSS-Inertial OEM board set plus Inertial Measurement Unit (IMU) in a compact form factor, designed to give system integrators the ability to harness the best in GNSS multi-frequency positioning technology.

 

  • Proven GNSS-Aided Inertial technology from Trimble Applanix
  •  Centimeter level mobile positioning accuracy
  •  Industry leading continuous positioning performance in GNSS denied environments
  • Full position and orientation solution for direct geo referencing of remote sensing systems
  • Fully supported for all dynamic environments: terrestrial, airborne and marine
  • High-performance GNSS two antenna heading aiding from single receiver
  • Solid-state, purpose-built ruggedized MEMS IMU featuring Applanix SmartCal™ compensation technology

AP10

The Trimble AP10 GNSS-Inertial System is a cost-effective, self contained GNSS-Inertial OEM board set plus MEMS Inertial Measurement Unit for continuous positioning during short or partial GNSS signal outages.

  • Proven GNSS-Aided Inertial technology from Trimble Applanix
  • Centimeter level mobile positioning accuracy
  • Industry leading continuous positioning performance in GNSS denied environments
  • Full position and orientation solution for direct geo referencing of imaging systems

POS MV

All POS MV models are designed for use with multibeam sonar systems, enabling adherence to IHO (International Hydrographic Survey) standards on sonar swath widths of greater than ± 75 degrees under all dynamic conditions. At the entry-level is the POS MV SurfMaster, which delivers robust georeferencing for small platforms, both manned and unmanned. SurfMaster is available both with a remote IMU and in single-enclosure form factor. Fully supported by Applanix’ industry leading post processing software, POSPac MMS, SurfMaster delivers roll and pitch accuracy to 0.03 degrees. Wavemaster II and OceanMaster are designed for increasingly difficult conditions and performance requirements. The POS MV Elite is for users seeking the very highest level of performance available to the industry POS MV comes in 4 models:

All POS MV models are designed for use with multibeam sonar systems, enabling adherence to IHO (International Hydrographic Survey) standards on sonar swath widths of greater than ± 75 degrees under all dynamic conditions.

Featurs

  • Applanix “TrueHeave™” software improves productivity and accuracy
  • Post-processing ensures high-quality results in difficult sea conditions
  • Optimally aided architecture ensures a high-quality solution if GNSS outages occur.
  • Applanix’ Inertially Aided RTK ensures more robust solution than standalone RTK
  • Decimetric positioning anywhere
  • Full GNSS Support – ensures robust solution in any environment
  • Accurate under all dynamic conditions
  • Heading accuracy maintained in high multipath environments and in areas of poor GNSS availability
  • Continuous sensor monitoring to ensure optimum performance
  • Almost instantaneous reacquisition of RTK following any GNSS signal loss
  • Automatic initialization upon power-up following a one-time calibration
  • Very low noise L1 and L2 carrier phase measurements
  • Superior low-elevation tracking performance regardless of latitude